The Master of Applied Science in Industrial Engineering is a thesis-based program designed to enhance specific areas of knowledge gained at the undergraduate level and to introduce students to the research methods of industrial engineering. You will have access to state-of-the-art laboratories and established research centres in a department that promotes interdisciplinary research and development in industrial control, computer-aided vehicle engineering, composites and computational fluid dynamics. Our department is at the forefront of research and graduate training in Canada. The program combines practical course work with a research thesis that allows you to focus on a topic of your choice. Students interested in the course-work master's program should refer to theMEng Program instead.
Bachelor’s degree in engineering or equivalent with high standing.
Proficiency in English
Proficiency in English. Applicants
whose primary language is not English must demonstrate that their
knowledge of English is sufficient to pursue graduate studies in their
chosen field. Please refer to the Graduate Admission page for further information on the Language Proficiency requirements and exemptions.
The requirements described here are in addition to the general degree requirements for the Master/Magisteriate in Applied Science (MASc).
Fully-qualified candidates are required to complete a minimum of 45 credits.
Please see the Engineering Courses page for course descriptions and prerequisites.
Industrial Engineering MASc (45 credits)
credits minimum chosen from the Gina Cody School of Engineering and Computer Science Courses section, approved by the student’s supervisor and either the Graduate Program Director or the Chair of the Department.
•ENGR 8901Master of Applied Science Research and Thesis (29.00)
4. An admission offer will not be issued until a supervisor match has been made. Students are encouraged to review the list of faculty members' field of interests and directly contact those with whom you would like to work.
For initial assessment purposes, scanned and uploaded copies of documents are accepted. To finalize a file, once admitted, Concordia University will require official documents.
Graduate students from the Mechanical, Industrial and Aerospace Engineering Department are invited to apply for Teaching Assistant positions. A minimal mark of A- in the course they are requesting to teach is needed. The priority level when assigning the graduate applicants is: Ph.D., M.A.Sc., and then M.Eng. Priority is to be given to students with good language abilities.